ONWA KA-GC9A , a 9-Axis Electronic Compass with Built-in High Accuracy GPS Module .
The KA-GC9A Customizable GPS Output Sentence, and Baud Rate NMEA0183 . Output Sentence : GPRMC , GPGSA, GPGGA, GPGLL , GPVTG, GPHDT (5HZ). Baud Rate:4800, All output sentence are in tntervales of 1Hz unless specified.
To connect the ONWA KA-GC9A electronic compass to your Lowrance HDS 9 for Heading data, follow these wiring and configuration steps:

- Physical Wiring
The KA-GC9A outputs NMEA 0183 signals. You need to connect its “Transmit” wires to the “Receive” wires on the HDS 9 Power/Data cable.
| KA-GC9A Wire Color | Function | Connect to HDS 9 Wire Color |
| Red | Power + (5V~32V) | Vessel 12V Positive |
| Blue | Power – (GND) | Vessel Negative / HDS Black Wire |
| Green | TX+ (Data Out) | Orange (RX+) / Receive Positive |
| White | TX/RX- (Signal Ground) | Green (RX-) / Receive Negative |
| Shield/Bare | Shield Ground | Vessel Common Ground |
Note: Since the KA-GC9A is the “Talker,” it must connect to the HDS “Receive” (RX) pins.
- Software Configuration (HDS 9)
Once wired, you must configure the HDS unit to recognize the incoming data:
- Set Baud Rate: Go to Settings > Network > NMEA 0183. Set the serial port baud rate to 4,800 (the default for the KA-GC9A).
- Select Data Source: Go to Settings > Network > Data Sources.
- Under the Heading category, change the source from “Scope: Internal” to the NMEA 0183 device.
- Verify Sentences: Ensure the HDS is receiving the HDT (Heading True) or HDM (Heading Magnetic) sentences from the compass.
- Installation Tips
- Alignment: Ensure the arrow on the KA-GC9A housing is pointing exactly toward the Bow (front) of the boat.
- Magnetic Interference: Mount the compass at least 1 meter (3 feet) away from magnetic materials, motors, or speakers.
- Calibration: If the heading is slightly off, you can use the ONWA “9-axis E-Compass Manager” software via a PC to perform fine-tuning and calibration.

